FITFIU FITNESS MC-500 Manual Usuario página 63

NOTE: The treadmill belt should not be too tight as this can cause noises and can damage the
engine.
TENSION BELT ADJUSTMENT
If the transmission belt needs tightening, you need to: use the key clockwise to tighten the bolt until the belt is tight
enough.
NOTE: Frequently clean objects or dust that may fall on the belt.
CORRECT USE OF THE SWITCHING DEVICE
Do not touch nor disconnect the switch with wet hands. When pulling the cable, hold it by the plastic part, not from
the cable itself. Do not place excessive weight over the cable. Do not twist the cable around the machine to avoid
damaging it. Do not use the equipment if the switch or the cable is loose.
TROUBLESHOOTING
The following information may assist you identifying a problem and rectifying it.
Problem
The equipment will A. Equipment not plugged in.
not start. B. Safety tether not in place.
Belt slips. Belt loose.
A. Not enough lubrication on running
Belt hesitates
deck.
when stepped on.
B. Belt too tight.
In case of left deviation, tighten the screw on the left (clockwise) or the right screw
(counterclockwise).
In case of right deviation, tighten the screw on the right (clockwise) or the left screw
(counterclockwise).
Cause
A. Connect unit to mains electrical supply.
B. Place safety tether in correct location.
Adjust belt tension.
A. Lubricate running deck.
B. Adjust belt tension.
63
MC-500
Solution
EN