Cleaning And Care - IKEA LAGAN Manual De Instrucciones

EN
Setting Weight Ib/Kg
Example: setting weight bJ etween pounds &
kilograms:
1. Touch Clock Settings pad 3 times.
2. Op-3 will display and the START+30
sec needs to be pressed to select.
3. Ib/kg aut o scrolls every 2 seconds
through each selection.
4. Touch START+30 sec pad to
confirm your selection.
NOTES
If the display shows kg, pressing the
will reset the oven controls to lbs. To return to kg,
you will have to again press
then press .
Setting Power Save Mode
Example: setting the demo mode on:
Suppose you want to enter Demo mode. When Demo
mode is ON programming functions will work in a rapid
countdown mode with no cooking power.
1. Touch Clock Settings pad 4 times.
2. Op-4 will display a nd the
START+30 sec needs to be pressed
to select.
3. on / oFF auto scrolls every 2
seconds through each selection.
4. Touch START+30 sec pad to
confirm when the display shows on.
Setting Demo Mode
Example: setting the power save mode on:
Turning On power save turns off the time of day
clock display.
1. Touch Clock Settings pad 5 times.
2. Op-5 will display a nd the START+30
sec needs to be pressed to select.
3. on / oFF auto scrolls every 2
seconds through each selection.
4. Touch START+30 sec pad to
confirm the LED shows no.
NOTES
START
When is pressed and the previous setting was
+30 Sec
OFF then it will be set to ON. If you want to turn the
demo mode back OFF you will have to again press
Clock
Settings seven times and then
button
three times and
START
.
press
+30 Sec

CLEANING AND CARE

Disconnect the power cord or leave the door open
to deactivate the oven during cleaning. Disconnect
the power cord before replacing filters and lights.
EXTERIOR
The outside surface is precoated steel and plastic. Clean
the outside with mild soap and water; rinse and dry
with a soft cloth. Do not use any type of household or
abrasive cleaner.
DOOR
Wipe the window on both sides with a soft cloth to
remove any spills or spatters. Metal parts will be easier
to maintain if wiped frequently with a soft cloth. Avoid
the use of spray and other harsh cleaners as they may
stain, streak or dull the door surface.
STAINLESS STEEL
BLACK STAINLESS STEEL(SOME MODELS)
Your microwave oven(some models) may have a
Stainless Steel finish or coating. Clean the stainless
with warm soapy water using a clean sponge or cloth.
Rinse with clean water and dry with a soft clean cloth.
DO NOT use ANY store bought cleaners like Stainless
Steel cleaners or any other types of cleaners containing
any abrasive, chlorides, chlorines or ammonia. It is
recommended to use mild dish soap and water or a
50/50 solution of water and vinegar.
TOUCH CONTROL PANEL
Care should be taken in cleaning the touch control
panel. If the control panel becomes soiled, open the
microwave oven door before cleaning. Wipe the panel
with a cloth dampened slightly with water only. Dry with
a soft cloth. Do not scrub or use any sort of chemical
cleaners. Close door and touch STOP/CLEAR
INTERIOR
Cleaning is easy because little heat is generated to
the interior surfaces. To clean the interior surfaces,
wipe with a soft cloth and warm water. DO NOT USE
ABRASIVE OR HARSH CLEANERS OR SCOURING PADS.
For heavier soil, use baking soda or a mild soap; rinse
thoroughly with hot water. The round wire rack and
shelf can be cleaned with hot soapy water, rinsed and
dried.
WAVEGUIDE COVER
The waveguide cover is located on the right side in the
microwave oven cavity. It is made from mica so requires
special care. Keep the waveguide cover clean to assure
good microwave oven performance. Carefully wipe with
a damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch fire.
DO NOT REMOVE THE WAVEGUIDE COVER.
17