Odor Removal; Turntable/Turntable Support; Cleaning The Grease Filters; Surface Light Replacement - IKEA LAGAN Manual De Instrucciones

Ocultar thumbs Ver también para LAGAN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ODOR REMOVAL

Occasionally, a cooking odor may remain in the
microwave oven. To remove, combine 1 cup water,
grated peel and juice of 1 lemon in a 2-cup glass
measuring cup.
Boil for several minutes using 100% power.
Allow to set in microwave oven until cool. Wipe interior
with a soft cloth.

TURNTABLE/TURNTABLE SUPPORT

The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non-abrasive
scouring sponge. They are also dishwasher-proof. Use
upper wirerack of dishwasher. The turntable motor shaft
is not sealed, so excess water or spills should be wiped
up immediately.

Cleaning the grease filters

The grease filters should be removed and cleaned often;
generally at least once every month.
Grease filter part number 5304478913
To order parts call (833) 337-4006
CAUTION
To avoid risk of personal injury or property damage,
wear gloves when replacing the light bulbs.
Surface lights
Tab
Grease filters
1. To remove the grease filters, slide the filter
to the rear. Then pull filter downward and push
to the other side. The filter will drop out. Repeat for
the 2nd filter.
2. Soak the grease filters in hot water using a mild
detergent. Rinse well and shake to dry or wash in Do
not use ammonia. The aluminum on the filter
will corrode and darken.
18
3. To reinstall the grease filter, slide it into the side

Surface light replacement

To avoid risk of personal injury or property damage,
wear gloves when replacing the light bulbs.
1. Unplug the microwave oven or turn off power at the
2. Remove the LED li ght cover moun ting screw under
Front
3. Remove the LED light mounting screw.
Rear
4. Unplug the LED light from the harness, replace with
5. Re-install LED light and mounting screw.
6. Re-install LED light cover and mounting screw.
7. Plug the microwave back into the power supply or
slot, then push up and toward oven to lock.
Reinstall the 2nd filter using the same procedure.
CAUTION
main circuit breaker.
the microwave.
part 5304499540.To order parts call (833)337-4006.
Then reconnect the harness.
When re-installing mounting screw be careful not to
damage the LED light.
turn the power back on at the main circuit breaker.
EN

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Medelnivå

Tabla de contenido