Oven light replacement
Remove the vent grill (see steps 1-4 in charcoal filter
replacement section.
1. Remove the light cover by carefully pulling up on the
front edge and pulling the cover forward.
2. Remove the LED bracket and light assembly.
Remove the LED light from the bracket by
removing the moun¬ting screw and replace only
with part 5304499540.
To order parts call (833)337-4006.
3. Re-install LED light to the bracket with mounting
screw. When re-installing mounting screw be
careful not to damage the LED light.
20
4. Reconnect LED light to the harness and place
the LED light assembly back into the plastic
housing.
5. Replace the microwave oven light cover by
carefully pushing into place (make sure the light
cover rear tab is inserted into slot at rear).
6. Replace the charcoal filter (if installed).
Push the vent grill back into place (engaging
both the bottom and top tabs) and replace the
vent grill mounting screws.
EN