Troubleshooting - Bestway 53310 Manual Del Usuario

be switched off from the supply mains prior to the beginning of any
such servicing or cleaning operation.
Clear Motor: Please replace lubricating oil on the bearing regularly. If
the bearing has worn down, you may replace it. To keep the Blower
clean you can use a dry cloth wipe the surface of the blower.
Deflation & Storage
IMPORTANT: All children must exit the slide park before deflation.
IMPORTANT: Store park in a secure place, away from children, to prevent suffocation. Never leave
either the park or the blower outside when not in use.
1. Turn off the blower motor and unplug it from the outlet.
2. Remove stakes from the park and the blower.
3. Fold the slide park toward the center.
4. Roll up the slide park tightly and compress the fabric to expel all of the remaining air.
5. Slip the carrying bag over the rolled-up inflatable park. Flip the bag and the park over, close the
bag, and store the park and the blower in a dry place.
Repair Patch Instructions
Replace defective parts in accordance with the instructions.
Please keep for future reference.
1
1. Defalte the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners.(See Fig.1&2).
3. Apply the repair patch:
Option #1: Using the vinyl patch.
Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
Option #2: Using the fabric patch and the glue (not included).
Apply only the amount of glue(not included) needed to cover the repair site and press patch firmly over the puncture.
4. Allow to sit for 30 minutes before re-inflating.
Warning
: Repair patched must be applied by an adult only. Keep out of children.

Troubleshooting

PROBLEM
Motor won't run
Motor runs but wheel makes a scraping noise
Motor is unable to run normally
303021193580_53310_14x21cm_滑梯蹦床说明书_英
2
correct
or
incorrect
1. Switch not turned on.
2. The circuit is opened or it is poor contact.
3. Electric capacity is damaged.
4. Choked up by hard objects.
1. Screws on the vaned wheel are loose.
2. Foreign objects in air-blower.
1. The voltage is unstable.
2. Motor is affected with damp.
3. Electric capacity is failure.
4. The impeller is loose.
5
CAUSE