Instructions Of Use; Steam Ironing; Dry Ironing - Jata electro CP816 Instrucciones De Uso

• If the cable were to deteriorate it must be changed by
an Authorised Service Centre.

INSTRUCTIONS OF USE

• For a correct functioning the appliance must be on a flat surface.
• If you are going to use the guide (15), insert in its housing.
• Open the lid (14) and using a bottle or jar pour water into the tank (13). You can also remove the tank
(13) by pulling it outward and pour water directly from the tap. Must not exceed the MAX indication in
the deposit. In the case of hard water can be used distilled water.
• If you have removed the tank for filling it, put it back in its original position and press firmly inward so
that it is correctly positioned.
• Set the iron temperature selector (4) to its maximum position (MAX) by turning it clockwise. If you wish
a lower temperature on the sole plate leave the temperature selector in (
• Plug the appliance into the mains and push the iron switch on (6) and the boiler switch on (7). Both
pilot lights (8 & 9) will light on.
• When this operation is done, the heating of the iron and the boiler will start, and the pump will start
to pass water from the tank to the boiler in a few seconds. The noise of the pump it's absolutely normal
when this happens.
• Await until the steam pilot light goes on (10) and the iron pilot light (3) goes off. At this moment the
appliance is ready to be used.

STEAM IRONING

• Remember that the iron temperature selector (4) must be set to its maximum position or in the steam
position ( ).
Intermittent steam
• Press the steam button (1) with your thumb for the steam begin to flow. It is advisable to use the button
in short intervals.
Continuous steam
• Press and slide backwards the steam button (2) if you wish continuous steam.
• To cut off the steam flow slide onwards the steam outlet lock button (2).
• Along using and as the steam is being consumed, the pump will pass automatically water from the tank
to the steam system.
• The steam caudal can be regulated at any moment using the regulator (12).
• When the water level is down, the low water pilot light (11) will go off and will stop the steam flow.
You can fill the tank.
• You can fill the tank at any moment bearing in mind that you must unplug the appliance from the mains
while doing it. If you have the precaution for keep the tank always with water, the appliance can work
in a continuous way, without need of waits.
• The pressure, the steam flow and the automatic filling of the steam chamber suppose the appliance can
work in a continuous way, making this appliance ideal for any type of ironing, including thick or large
garments.
• You can also iron curtains and other garments vertically without needing to take them down. Bring near
the iron in vertical position to the garment and use the steam outlet lock button (2).

DRY IRONING

• Plug the appliance into the mains, push the iron switch on (6) and set the temperature selector (4) in
the desired position.
FIBRAS SINTÉTICAS / SINTHETIC FIBRES: Soft temperature (•)
SEDA – LANA / SILK – WOOL: Medium temperature (••)
ALGODÓN – LINO / COTTON – LINEN: High temperature (•••)
13
) position.