Instructions Of Use; Steam Ironing - Jata electro CP255 Instrucciones De Uso

• The possible rests of water in the tank are due to the quality controls done
in our production lines.
• The cleaning and maintenance done by users, can not be done by children
without any supervision.
• If the cable were to deteriorate it must be changed by an Authorised
Service Centre.

INSTRUCTIONS OF USE

• Remove the cap (8) of the boiler. To do that turn it anti-clockwise.
• With the help of a bottle or a jug pour water into the boiler. You must never pour more than 0.5
litres of water, which is its useful capacity, into the boiler. You may use tap water or in the case
of very hard waters you may use distilled water.
• Replace the lid (8), by turning it clockwise until the end.
• Set the iron temperature selector (4) to its maximum position (MAX) by turning it clockwise. If
you wish a lower temperature on the sole plate leave the temperature selector between the steam
indication marks (
• Plug the appliance into the mains and switch on the power switch (6) to the I position. This switch
will light on.
• When this operation is done, the heating of the iron and the steam system start.
• Await until the PREPARADO indicator (7) light on and the iron pilot light go off. At this
moment the appliance is ready to be used.
• The time to light on the PREPARADO indicator depends of the amount of water poured into the
boiler.

STEAM IRONING

• Remember that the iron temperature selector (4) must be set to its maximum position.
Intermittent steam
• Press the steam button (1) with the index finger for the steam to begin to flow. It is advisable to
use the button in short intervals.
Continuous steam
• Press and slide backwards the steam button (2) if you wish continuous steam.
• To cut off the steam flow slide onwards the steam outlet lock button (2).
• The pressure and the steam flow make this appliance irreplaceable for any type of ironing, including
thick garments or great dimensions.
• You can also iron curtains and other garments vertically without needing to take them down.
Bring near the iron in vertical position to the garment and use the steam outlet lock button (2).
Dry ironing
• Plug the appliance into the mains and press the on switch (6) to the I position and set the
temperature selector (4) in the desired position.
FIBRAS SINTÉTICAS / SINTHETIC FIBRES: Soft temperature (•)
SEDA – LANA / SILK – WOOL: Medium temperature (••)
ALGODÓN – LINO / COTTON – LINEN:High temperature (•••)
• When the iron pilot light (3) is off, the iron has reached the selected temperature.
• If before dry ironing you have been ironing with steam do not press the steam button (1).
BOILER REFILL
• If while you are ironing the steam flow stop flowing you must proceed to refill the boiler.
• To do so, you must first release the pressure in the boiler following one of the next methods:
A.- Turn slightly the lid (8) anti-clockwise for the rest of the steam to escape. Once you have
checked that there is no steam left in the boiler you may slowly finish unscrewing the lid,
to empty the appliance or to refill it.
B.- Wait for the appliance to cool down and loose all its pressure.
• If you are going to refill the boiler and it is still hot, it is convenient to use warm water to avoid
the thermal contrast. Else, you could get steam or boiling water could come out of the boiler.
).
9