Assembly And Adjustments - Powersmart PSS2260L Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND ADJUSTMENTS

The following section describes steps necessary to prepare the snow thrower for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service assistance. Failure to perform these steps properly can damage the snow
thrower.
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1. Snow Thrower
2. Discharge Chute Assembly
3. Chute Rotation Handle
4. (Qty. 2) one set of Skid Shoes with attaching hardware
5. (Qty. 4) extra M6 Shear Pins and M6 Locknuts
6. Speed control connection Rod.
7. 20oz 5W-30 oil
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using your
Snow Thrower.
WARNING: This snow thrower is heavy. Assembly procedures may require lifting
equipment utilizing two people.
Step 1: Installing the Upper Handle
1. When installing the Upper Handle, please note that the Drive & Auger Cables will already be
pre-attached to Upper Handle.
2. Attach Upper Handle using the Frame Handle Assembly Hardware (4 sets /Knob, Saddle
Washer, M8 Nut, T-Screw) for your Upper & Lower Handle connection.
3. When attaching Assembly Hardware, make sure ALL cables are underneath the Frame (Upper &
Lower) Handles after installation as indicated in Figure1. VERY IMPORTANT!!!***
12
Figure 1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido