Euroflex monster EZ2-S Manual De Instrucciones página 11

C. Attach Hard Surface Floor or Carpet Pad to Steamer
Affix either the Hard Surface Floor Pad or Carpet Glide with Carpet Pad to your Floor Steamer.
WARNING:
To prevent floor damage, ALWAYS attach either the HARD SURFACE FLOOR PAD or the CARPET GLIDE ACCESSORY
with CARPET PAD when using your Floor Steamer. NEVER use without either of these attachments affixed to the machine.
ATTACHING HARD SURFACE FLOOR PAD
Place Floor Pad face down on the floor, wide side forward, with white hook and loop strips
facing up. Hold Floor Steamer about 2" above Pad and gently place Floor Steamer onto the
Pad. Firmly press down to assure Pad is securely adhered to the Floor Steamer.
ATTACHING CARPET GLIDE WITH CARPET PAD
Place Carpet Glide face up on floor. Center and place Carpet Pad on top of Carpet
Glide, wide side forward, with white hook and loop strips facing up. Hold Floor Steamer
about 2" above Pad and gently place Floor Steamer onto the Pad. Firmly press down
to assure Pad is adhered to the Floor Steamer and Carpet Glide is securely attached.
USE ON HARDWOOD FLOORS
For hardwood floors, use only on "sealed" hardwood surfaces.
Carefully control the amount of steam usedwhen cleaning, as too much water could
cause damage
IMPORTANT NOTE ABOUT LINOLEUM FLOORING
S
team can cause wax to be stripped from, and consequently damage, some varieties of
linoleum flooring. ALWAYS test a small, inconspicuous portion of the floor BEFORE using steam
to ensure that your linoleum floor does not have this issue.
D. Filling Boiler with Water
WARNINGS:
• Carefully read all instructions before removing Boiler Cap. • Always unplug appliance before filling the Boiler.
IMPORTANT
Use tap water – distilled or demineralized water if tap water is too hard.
DO NOT ad detergents, perfumes, oils or other chemical substances.
Follow these instructions to avoid overfilling
the Boiler.
• Be sure appliance is unplugged, and has cooled for at least 10 minutes before
filling with water.
• Make sure Handle Assembly is in the upright "off" position.
Remove Boiler Cap by pressing it down and turning it counterclockwise.
IMPORTANT
If re-filling the Boiler while Steamer has been in use, be sure to allow Steamer to cool
for at least 10 minutes and loosen Boiler Cap slowly to allow any excess steam to
escape before com-pletely removing Cap. (See step 2D, "Refilling Boiler During Use"
for detailed instructions.)
1 Cup
1/2 Cup
• Replace Boiler Cap by pressing it down and turning it clockwise. If using
cold water, heating time is about 3-7 minutes. If using warm water, heating
time is reduced.
NOTE: You can change the microfiber pad when the unit is warm or hot.
• Pour in two (2) cups of water using the Measuring
Cup provided – fill cup to the "1 Cup" marking two times.
Be careful not to overfill – NEVER add more than 2 cups of water.
11