Rinsing The Boiler - Euroflex monster EZ2-S Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

C. Using Floor Steamer
• To start cleaning using the bottom steam ports and a microfiberpad,
simply pull the Handle downward.
You will find that your Floor Steamer can easily clean and refresh most
hard surfaces and floors using the underside steam alone.
NOTE
: Some water may be emitted. This is normal.
• To emit steam or Clean Blast from the Steam Nozzles (at front of
Steamer), pull the trigger on the Handle.
REMINDER
The Steam Nozzles are meant to be used in steam"bursts" and should
never be used on a sustained basis. The Steam Nozzles will loosen
especially difficult debris and will also assist in getting into hard to
reach areas and corners.
MAXIMUM SANITIZATION will occur when your Steamer is being used
with Clean Blast.
NOTE:
Depending on the frequency of use of Steam Nozzles, your Boiler will not need to be
refilled for up to 30 minutes.
• To stop steam, simply return Handle to the upright position.
The Floor Steamer will stop producing steam when the Boiler is empty. When this happens, refill
with water per instructions (see step 2D, "Refilling Boiler During Use") or unplug and store unit.
D. Refilling Boiler During Use
WARNING:
Let Steamer cool 10 minutes before opening Boiler Cap. Use care when opening Boiler Cap as it may still
be hot and steam may escape, causing burns. If Boiler is still hot, water may spurt out during refilling which can also
cause burns.
• Unplug appliance.
• Press trigger on the Handle to clear steam from Steam Nozzles.
• Press down on and slowly turn Boiler Cap counterclockwise. This will allow remaining steam to escape.
• Be sure Steamer has cooled 10 minutes before refilling with water.
• Fill Boiler using Measuring Cup provided - two times using the "1 Cup" mark. Be sure Steamer Handleremains in the
upright "off" position.
• Firmly push down and screw Boiler Cap back on by turning it clockwise.
• Insert plug into 3-prong electrical outlet.
REMINDERS
• Always use tap water.
• If tap water is too hard, use distilled or demineralized water to avoid the risk of staining pale colored fabrics.
• Do not add detergents, perfumes, oils or other chemical substances.
If distilled or demineralized water is regularly used there is no need to clean the Boiler.

Rinsing the Boiler

We reccomend you periodically rinse the Floor Steamer to prevent the accumulation of calcium and sediment caused
by hard water use. After 10 - 15 uses, fill the Boiler 3/4 full with hot tap water, shake several times and empty out into sink
or bathtub. Wipe the Steamer base with a damp cloth and wipe dry.
NEVER HOLD THE STEAMER UNDER TAP TO FILL. Use Measuring Cup provided to fill.
CLEANING AND RINSING FLOOR STEAMER
13

Publicidad

Tabla de contenido
loading

Tabla de contenido