Using Your Floor Steamer; Starting The Appliance - Euroflex monster EZ2-S Manual De Instrucciones

E. The Sanitizing System
This Monster EZ2 Superclean Steamer is equipped with a unique on-demand option designed
to sanitize your non-porous hard floor surfaces (sealed wood, tile, marble, granite, linoleoum,
etc.). Included in this package is an 8 oz. bottle of "Clean Blast", a special sanitizing agent that
will quickly kill up to 99,9% of germs and bacteria – including Norovirus, MRSA, E-coli, Staph,
Salmonella and black mold. Be sure to use as directed.
ADDING CLEAN BLAST SANITIZER
• Push Clean Blast Tank Cover in the upward direction (as shown in "A") to reveal opening.
• Use provided Measuring Cup to fill the Clean Blast Tank (Figs. "B" and "C").
Pour Clean Blast into Measuring Cup up to the "Clean Blast (Max)" marking.
We recommend tilting the Steamer back when filling the Clean Blast Tank.
Be careful not to overfill.
REMEMBER: YOU CAN FILL THE CLEAN BLAST TANK WHEN THE STEAMER IS
ON AND HOT. BUT NEVER FILL THE BOILER TANK WHILE THE STEAMER IS HOT!
D
• The sanitizer is delivered to the surface only through the front ports of the EZ2 Steamer "F"
WARNING:
Only use CLEAN BLAST sanitizer.
The EZ2 Steamer was designed to be used with Clean Blast only. Any other cleaning solution
used may harm your Steamer and will void the warranty.
HINT
: A little Clean Blast goes a long way – no need to soak your floor.
A. Using the Parking Pad
*IMPORTANT*
The Parking Pad is provided to prevent floor damage that can result from leaving a hot steamer
on the same spot for more than a few minutes. ALWAYS place Floor Steamer on the Parking Pad
when not in use, or while it is cooling before storage.
You can use the Parking Pad if the Steamer is warm or hot.
B. Starting the Appliance
• Be sure Boiler is filled with water, Boiler Cap is securely in place and Clean Blast (if using) has
been added to Clean Blast Tank.
• Insert the plug into a-3 prong grounded electrical outlet (orange Power Indicator Light will
illuminate).
• Keep the handle in the upright "off" position.
Wait until the (green) Steam Ready Indicator Light illuminates.
• Once Boiler is filled and the green Steam Ready Indicator Light illuminates, the EZ2 Floor
Steamer is ready to clean.
- Steam temperature at the nozzle end is between 104°C / 219°F and 115°C / 239°F.
- Temperature lowers to 38°C / 100° F at a distance of 25cm /10 in. from the nozzles.
• Close the Clean Blast Tank Cover "D".
• You can now sanitize on demand by
pulling back the Trigger on the Handle "E".

USING YOUR FLOOR STEAMER

12
1 Cup
1/2 Cup
B
E
trigger
F
.
A
C