Bissell CleanView Plus 4207 Serie Guia Del Usuario página 11

M
aintenance and care
Replace drive belt
use only a genuine bissell style 9
replacement belt (#203-1093) in your
bissell cleanView vacuum.
1. unplug cleaner from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of check
rotating floor brush and drive belt),
grasp old drive belt and remove from
motor pulley. discard old drive belt.
3. place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
4. place ends of rotating floor brush
down into slots on sides as shown.
5. turn rotating floor brush by hand
several times in the direction of motor
pulley. if properly installed, drive belt
will center itself on rotating brush.
6. Reposition the brush cover and screw
all seven screws back into place.
w w w . b i s s e l l . c o m
4.
Motor
Pulley
8 0 0 . 2 3 7 . 7 6 9 1
11