Bissell CleanView Plus 4207 Serie Guia Del Usuario página 5

A
ssembly
the only tool you'll need to assemble your
vacuum cleaner is a phillips head screwdriver.
Attach handle to vacuum
1. locate the vacuum handle and remove
the screw packet taped to the handle.
the screw packet contains two screws of
equal length.
2. stand the vacuum upright and slide the
base of the handle firmly into the open-
ing at the top of the vacuum body.
3. check to be sure the handle is fitted to
the vacuum body. if there are any gaps
between the handle and the vacuum
base, continue to push the handle firmly
into the base until the handle is flush.
4. insert the two screws from the screw
packet into the existing holes. push
each screw firmly into the hole before
beginning to secure the screw with a
phillips head screwdriver. if the handle
is aligned properly on the vacuum base,
you should be able to push the screw
almost entirely into the hole until only the
screw head is visible. tighten the screw
with a phillips head screwdriver by rotat-
ing the screw clockwise.
Attach vacuum hose, clips & tools
1. attach the extension wand clip by insert-
ing the clip into the back of the vacuum
base and twisting clockwise. Mount the
extension wand (with crevice tool inside)
on the back of the vacuum.
2. snap the upper cord wrap into the sock-
et located above the extension wand
clip. Wrap the power cord around the
cord wrap clips.
3. attach the twist 'n snap™ hose by
lining up the tabs on the cuff with the
corresponding notches on the back of
the vacuum. twist the twist 'n snap hose
clockwise to lock the hose into place.
4. slide the end of the hose wand into the
hose wand base, and fold the hose over
the upper hose wrap.
NOTE: The powerfoot will not
suction properly unless the hose
wand is firmly attached.
5. slide the dusting brush into the opening
below the upper hose wrap.
6. the turbobrush tool secures to the back
of the handle in the mount above the
upper hose Wrap.
w w w . b i s s e l l . c o m
2.
4.
1.
2.
3.
4.
8 0 0 . 2 3 7 . 7 6 9 1
6.
5.
2.
3.
1.
3.
4.
5