Power Cord Storage; Maintenance And Care - Bissell CleanView Plus 4207 Serie Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

O
perations

Power cord storage

When you have finished using your bissell
cleanView vacuum, return it to the upright
position and store the power cord.
1. turn vacuum cleaner off.
2. unplug power cord by grasping the
polarized plug (not the cord) and
disconnect from outlet.
3. Wrap power cord around cord wraps
located on the back of the vacuum.
4. clip molded plug to power cord to secure.
M
aintenance and care
to maintain maximum cleaning performance, the
following maintenance steps must be performed:
1. empty the dirt tank when the dirt reaches
the "full" line on the side.
2. check the pre-motor filter at least once a
month and clean or replace as needed.
to access the pre-motor filter, remove the
easy empty dirt tank from the vacuum base
and push the lid release button located on
the carry handle. Remove the foam filter
from the filter tray.
3. the post-motor filter assists in the filtration
process to return clean air to the room.
Replace the post-motor filter every three to
six months. to access the post-motor filter,
remove the filter tray located below the easy
empty dirt tank. When the filter becomes
dirty, push the filter through the bottom of the
tray to clean or replace the filter.
NOTE: the white, pleated post-motor
filter may NOT be washed with
water or detergent. If dust and/or
debris accumulates on the filter,
gently tap the filter on the side of a
garbage container.
NOTE: More frequent filter cleaning
or replacing may be necessary if you
are vacuuming new carpet, fine dust,
or have allergy concerns. Follow the
instructions on the following pages
to perform these simple maintenance
steps.
8
w w w . b i s s e l l . c o m
NOTICE:
While vacuuming, certain carpets
and low humidity conditions may
generate small static discharges. the
discharges are entirely harmless and
are not associated in any way with
the main power supply.
WARNING:
to reduce the risk of electric
shock, turn power switch off
and disconnect polarized plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
2.
3.
post-Motor
filter tray
lid Release
button
8 0 0 . 2 3 7 . 7 6 9 1

Publicidad

Tabla de contenido
loading

Tabla de contenido