Burying The Boundary Wire; Software Update; Maintenance; Keep It Sharp - Worx Landroid S Basic Manual Del Propietário

a separate location. It is important to leave the necessary length where it connects to the Charging Base so it can be
connected and still remain buried.

6.2 Burying the Boundary Wire

If you are planning to bury the Boundary Wire, it is recommended to first peg it down. This allows you to easily change the
layout if necessary before burying the wire. When the boundary wire installation is complete, have Landroid
the path by pressing and
®
While observing Landroid you can easily make alterations to the boundary wire to ensure the Landroid
tracking when locating the charging station. Confirm that Landroid
wire if desired.
7.

Software update

The software can be updated when new versions become available. The latest software can be downloaded from our
website www.worxlandroid.com.
Update via USB. See below for download and installation instructions:
(1) Locate the latest software version at: www.worxlandroid.com.
Save the file to an empty FAT32 formatted USB (flash drive).
Delete any other files on the drive and check the format. If the
drive is not formatted in FAT32, please reformat the drive.
NOTE: the software update is downloaded as a zipped file. You
will need to unzip or extract it before proceeding.
®
(2) Place Landroid on a secure and level surface. Turn the Main
Switch to the "O" position to turn off your Landroid
(3) Lift the rear of the Landroid
(4) Open the protective rubber cover under the Landroid
the USB port.
(5) Insert the USB drive (flash drive) in the port. (See Fig. K)
®
(6) Place the Landroid on the ground again.
(7) Turn the Main Switch to the "I" position to turn on the Landroid
(8) The battery indication light will start to pulse. When the error
indication light flashes blue, the file has been copied.
(9) Without lifting the Landroid
(10) The update will begin automatically and may take several minutes. The final alert sequence will include a beep, and both
the battery indication light and error indication light will flash. When the error indication light turns off and only the green
battery indication light remains lit, the update is complete.
NOTE: If the Landroid ®
refer to the manual for more information.
(11) Be sure to tightly and completely close the rubber protective USB port cover.
The manual included with your Landroid
functions in the new version may not exist in the manual. If you found some settings not in the manual, please visit www.
worxlandroid.com to download the latest manual.
8.

Maintenance

®
Your Landroid works hard and needs to be cleaned and checked from time to time. Some parts will require replacement
as they become worn. Never use your Landroid
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your Landroid

8.1 Keep it sharp

WARNING: Before cleaning, adjusting, or replacing the Blades, turn your Landroid
put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
Owner's Manual of Lawn Mowing Robot EN
®
. This will allow Landroid
®
®
to access the underside.
®
, remove the USB drive (flash drive).
is not inside the boundary wire, the error indication light will flash RED after the update. Please
®
is based on the default software at the time of production.Some new features/
®
with defective main switch.
®
.
to adjust to its new environment.
®
docks in the charging station successfully, and bury the
.
®
to access
®
.
K
®
follow and check
®
's trouble-free
®
OFF and
13