Beko CWB 9560 X Manual Del Usuario página 11

3 Operating your appliance
Commands (Fig.10) mechanical the
key symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
Commands luminous (Fig.11) the
key symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes (*)
If your appliance has the INTENSIVE speed func-
tion, from speed THREE, press key E for 2 seconds
and it will be activated for 10 minutes after which
it will return to the previously set speed. When the
function is active the LED flashes. To interrupt it
before the 10 minutes have elapsed, press key E
again. Some models allow activating this function
even with speed one and two.
By pressing key F for two seconds (with the hood
switched off) the "clean air" function is activat-
ed. This function switches the appliance on for ten
minutes every hour at the first speed. As soon as
this function is activated the motor starts up at the
first speed for ten minutes. During this time key F
and key C must flash at the same time. After ten
minutes the motor switches off and the LED of key
F remains switched on with a fixed light until the
motor starts up again at the first speed after fifty
minutes and keys F and C start to flash again for
ten minutes and so on.
By pressing any key for the exclusion of the hood
light the hood will return immediately to its normal
functioning (e.g. if key D is pressed the "clean
air" function is deactivated and the motor moves
to the 2nd speed straight away. By pressing key B
the function is deactivated).
Cooker Hood / User Manual
(*) The "AUTOMATIC STOP TIMER" delays
stopping of the hood, which will continue function-
ing for 15 minutes at the operating speed set at
the time this function is activated.
Anti-grease/active charcoal filters
saturation:
When the A key flashes with a 2 second fre-
•
quency the antigrease filters must be washed.
When the A key flashes with a 0.5 second
•
frequency the active carbon filters must be re-
placed or washed depending on the type of filter.
Once the clean filter has been put back one must
reset the electronic memory by pressing the A key
for approximately 5 seconds until it stops flash-
ing.
Commands (Fig.12):
Push-button A = On/off lights switch.
Push-button B = On/off cooker hood switch.
The appliance switches on at speed level 1, If the
cooker hood is on depress the push-button for 2
sec. to switch off the cooker hood. If the cooker
hood is at speed level 1 it will not be necessary
to depress the push-button to switch the cooker
hood off. Decreases the motor speed.
Display C = Indicates the motor speed level se-
lected and activates the timer.
Push-button D = Switches on the cooker hood.
Increases the motor speed. Touching the key at
3rd speed, the intensive function runs for 10',
then the appliance go back to work at the original
speed. During this function the display blinks.
Key E = The Timer times the functions on activa-
tion for 15 minutes, after which they are switched
off. The Timer is deactivated by re-pressing Key
E. When the Timer is activated the decimal point
must flash on the display. The Timer cannot be ac-
tivated if the intensive speed is functioning.
11 / 30 EN