1
Important instructions for safety and environment
General
Carefully read the following impor-
tant information regarding installa-
tion safety and maintenance. Keep
this information booklet accessible
for further consultations. The appli-
ance has been designed for use in
the ducting version (air exhaust to
the outside - Fig.1B), filtering ver-
sion (air circulation on the inside
- Fig.1A) or with external motor
(Fig.1C).
Safety precaution
Take care when the cooker hood
•
is operating simultaneously with
an open fireplace or burner that
depend on the air in the environ-
ment and are supplied by other
than electrical energy, as the
cooker hood removes the air from
the environment which a burner
or fireplace need for combustion.
The negative pressure in the en-
vironment must not exceed 4Pa
(4x10-5 bar). Provide adequate
ventilation in the environment for
a safe operation of the cooker
hood.
Follow the local laws applicable
for external air evacuation.
6 / 30 EN
Before connecting the model to
the electricity network:
Control the data plate (positioned
•
inside the appliance) to ascertain
that the voltage and power cor-
respond to the network and the
socket is suitable. If in doubt ask
a qualified electrician.
If the power supply cable is dam-
•
aged, it must be replaced with
another cable or a special assem-
bly, which may be obtained direct
from the manufacturer or from the
Technical Assistance Centre.
This device must be connected to
•
the mains supply through either a
plug fused 3A or hardwired to a 2
phase spur protected by 3A fuse.
In certain circumstances
A
electrical appliances may
be a danger hazard.
Do not check the status of the fil-
•
ters while the cooker hood is op-
erating.
Do not touch bulbs or adjacent
•
areas, during or straight after pro-
longed use of the lighting instal-
lation.
Flambè cooking is prohibited un-
•
derneath the cooker hood.
Avoid free flame, as it is damaging
•
for the filters and a fire hazard.
Cooker Hood / User Manual