Maintenance And Care - Miele SEB 236 Instrucciones De Manejo

The Electrobrush switches itself off
but the indicator lamp remains green
The overheating protection mechanism
has been activated by the appliance
overheating or because of a blockage.
^ Switch the vacuum cleaner off, switch
off at the wall socket and remove the
plug.
The Electrobrush has to cool down. To
speed this up:
^ Reconnect the vacuum cleaner to the
Electrobrush and switch the vacuum
cleaner on.
^ Raise the suction tube and
connection socket to the vertical
position.
The Electrobrush will be ready for use
again after about ten minutes.
The light tube needs changing
See illustrations i and j
Light tube specification:
– Fitting: G5
– Size: 16 x 212
– Wattage: 6 watts
– Shade: cool white
^ Switch the vacuum cleaner off, switch
off at the wall socket and remove the
plug.
^ Release the Electrobrush connection
socket.
^ Loosen the four fixing screws
underneath the Electrobrush a.
^ Take off cover b and roller connector
c.
^ Unscrew the four fixing screws d
which are now visible and separate
the base section e from the top
section f.
^ Replace the light tube.
^ Reassemble the Electrobrush by
reversing the procedure.

Maintenance and care

Removing threads and hairs
See illustration k
^ Switch the vacuum cleaner off, switch
off at the wall socket and remove the
plug.
^ Cut any threads or hairs that have
become entangled in the roller with a
pair of scissors.
There is a groove along the roller to
help you. Then run the vacuum cleaner
to vacuum up the bits.
G
13