Special Safety Instructions - Rothenberger ROCAM 3 Instrucciones De Uso

b) Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfami-
liar with the power tool or these instructions to operate the power tool. Power tools
are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tools operation. If
damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
f)
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these instruc-
tions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a
hazardous situation.
5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer. A charger that is suitab-
le for one type of battery pack may create a risk of fire when used with another battery pack.
b) Use power tools only with specifically designated battery packs. Use of any other
battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal objects like paper
clips, coins, keys, nails, screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
6) Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
2.

Special safety instructions

Always wear work gloves for all tasks.
Do not perform any work inside the device! Only trained technical personnel (customer service)
are allowed to work in this area!
It is prohibited to use the TV inspection system for medical uses of any sort.
Do not use force to pull the camera and reel cable out of the pipe!
The reel cable is rigid and is therefore under mechanical stress! Hold firmly when unwinding from
the reel!
Keep a firm footing.
According to UVV, the minimum distance must be 50 cm (average 64 cm)!
Do not store batteries together with metal objects (short circuit hazard).
Charge the battery only in ROCAM®; do not use any other charging devices.
Do not open batteries or chargers, and store them only under dry conditions. Protect from mois-
ture.
Always set the pipe cable next to the „axis"; otherwise there is a risk of injury!
ENGLISH 25