Samsung RF4289HA Manual Del Usuario página 24

WI-FI NETWORKS
When you set Wi-Fi ON, (see above) the refrigerator's wireless network function searches for a wireless
AP to connect to.
• In addiion to the router installed in your home, your refrigerator can detect other wireless routers
installed in nearby houses or offi ces while connecting to your wireless network. It is illegal to use
CAUTION
another's router without permission and can be subject to severe penalties. Consequently, you
should connect the refrigerator only to your own wireless router or to routers for which you have
permission.
1. Press the button in the right bottom corner of the Settings list.
2. Select [Wi-Fi Networks] in the Settings list.
3. Select the wireless AP you want to connect to.
• : Locked with Security Code
• : Signal Strength
• You can check the MAC address of the Fridge on
the bottom of the Screen.
• If there are no APs showing on the screen, press the [Search] menu at the bottom.
• Depending on the wireless AP type, the refrigerator may not make a connection.
We recommended you use a wireless AP that supports IEEE802.11b/g/n.
• If you don't have a wireless router, please contact your internet provider or purchase and install
one yourself.
• If you can't remember the name of your wireless network system (SSID) or its security code,
please see the user manual of your router.
• Radio frequency signals can interfere with any the wireless network system and they may affect
the network performance of your refrigerator.
• Obstacles such as concrete walls and metallic doors and radio and microwave interference from
devices such as microwave ovens can affect the operation of your wireless network system.
• Depending on the type and location of your wireless network system and the surrounding
environment, the range and quality of your wireless network may vary.
4. If your wireless network has a security code enter the
security code, and then press the [OK] button.
In most cases, after you have entered the security
code, the refrigerator acquires the Network addresses
it needs (IP Address, Subnet Mask, Gateway, and DNS)
to connect to the network. If it does not or you need to
enter these values manually, go to Step 6.
68_ operating
DA68-02520A(1.0).indb 68 DA68-02520A(1.0).indb 68 2012.5.30 10:41:37 AM 2012.5.30 10:41:37 AM