Trim Installation; Important - Delta MultiChoice 13 Serie Manual Para Propietarios

Installation
Adjusting the Rotational Limit Stop
3
Stem
Rotational Limit Stop

IMPORTANT:

The Rotational Limit Stop is used to limit the
amount of hot water available such that, if set
properly, the user will not be scalded if the handle
accidentally is rotated all the way to "hot"
LEAST amount of hot
water to mix with the cold water in the system.
possible when the handle is turned all the way
to hot. As you move the Rotational Limit Stop
counterclockwise, you progressively add more
and more hot water in the mix. The last position
to the left will result in the greatest amount of
hot water to the mix, and the greatest risk of
scald injury if someone accidentally turns the
valve handle all the way to the hot side while
WARNING: In some instances, setting the
Rotational Limit Stop in the hottest position
(full counterclockwise) could result in scald
injury. It is necessary to adjust the Rotational
Limit Stop so that the water coming out
of the valve will not scald the user when the
handle of the valve is rotated to the hot side.
the maximum allowable temperature of the water
codes may require a water temperature less than
1
adjusted seasonally if the inlet water temperature
the cold water temperature is colder than it is
during the summer which could result in varying
outlet temperatures. A water temperature
1st Position
for a comfortable bath or shower is typically
cold as it will get and hot water is as hot as
it will get. Place the handle on the stem (see
terclockwise until the handle stops.
and hold in the water stream. If the water
Limit Stop must be repositioned clockwise to
decrease valve outlet water temperature to
requirements
of your local plumbing codes.
coming out of the valve, pull the disc back to
a position where it is possible to remove the
Rotational Limit Stop and readjust the teeth
engagement position to the desired temperature.
Clockwise will decrease the outlet
temperature, counterclockwise will increase
the outlet temperature. Temperature change
inlet water conditions. Repeat as necessary.
Push disc until fully seated.
WARNING: Failure to re-install Disc after
setting Rotational Limit Stop could result
in scald injury.
6

Trim Installation

4
A.
3
4
2
4
3
1
Slide O-ring (1) over cartridge and the
bonnet nut (2). The O-ring, which acts as
a spacer to steady the sleeve, should rest
behind the bonnet nut.
If your model requires a spacer (3), insert
it into the sleeve (4) and push it to the
front. Slide the sleeve over the cartridge,
body and O-ring.
C.
2
3
1
1
Using an Allen wrench to secure the set
screw (1), install the handle (2) onto the
stem. Insert plug button (3) (if your model
has one) into set screw hole.
Installation
B.
1
4
5
Escutcheon Installation for
Models T14053, T14253 & T14453.
6
5
7
9
8
8
Secure the escutcheon (1) and backplate (2)
(if your model has one) to the bracket (3) using
escutcheon screws. If you are installing the
Cassidy models T14097, T14297 & T14497:
Thread the cover (5) onto the escutcheon (1).
For models T14053, T14253 & T14453:
Install bracket (5) over the cartridge body using
by placing it over the bracket as shown and
rotating it to lock the tabs (8). Secure the escutc-
heon to the bracket using set screw (9).
3