Klarstein Baltrum Manual Del Usuario página 23

Increase/ Decrease (Modell 10035034)
1. If no temperature setting or timer setting has been made, the + and - buttons light up
only dimly and do not react when pressed.
2. If a temperature and/or timer setting has been made, the + and - buttons light up
and are activated.
3. If, once the temperature is set, you press the + and - buttons simultaneously,
the temperature unit can be changed from "°C" to "°F". In the same way, the
temperature unit can be changed from "°F" to "°C" again.
4. The factory-set temperature is 75 °F, the temperature setting range is 45 - 95 °F.
5. The instrument has a memory function for the temperature unit. Even after a power
failure, the last temperature unit set is restored.
Tilt protection (Modell 10035033 und 10035034)
1. If the angle between the horizontal and vertical positions is less than 30 ±5
degrees, the digital display will blink and show "Eo". All instrument functions are
automatically turned off.
2. The unit must be turned off and on again after the unit is returned to the correct
position to resume operation.
Notes
1. If no adjustment is made in the operating mode within 3 minutes, the screen goes
out automatically. Only the on/off button is dimmed. The other buttons are out. To
turn on the screen again, press any key.
2. If a short circuit of the sensor occurs, "EH" will flash on the screen. If a sensor is
exposed, "EL" is displayed on the screen. In either case, turn the power off and
contact customer service for repair.
3. The unit can be controlled via remote control.
EN
23