Insertion Of Batteries - LaserLiner ActiveFinder Manual Del Usuario

Overvoltage category III: Equipment in fixed installations
and for applications where specific requirements with
regard to the reliability and availability of equipment
have to be met, e.g. circuit-breakers in fixed installations
and devices used in industrial applications which are
permanently connected to the fixed installation.
1

Insertion of batteries

The device is ready for use immediately once the batteries
!
have been inserted. It does not have a separate ON/OFF
switch and is therefore always active.
1
1
Detector tip
2 ZOOM function
ON/OFF
Before using the device, you should always test it on a
main circuit you know to be operational within the specified
!
voltage range. To avoid inaccurate measurements, check the
device batteries prior to use by switching on the built-in
battery lamp (see 4).
2
Localising electrical voltages
Position the detector tip in the
area to be tested (e.g. cable,
socket. etc.).
!
For safety, check all three phase conductors (L1, L2, L3) for
the presence of voltage!
!
If the acoustic signal is weak or the battery lamp is not as
bright as it should be, replace the batteries.
06
GB
2
6
3
Pocket clip
4 Battery lamp
ON/OFF
If voltage is present, the detector
tip lights up and a signal sounds.
AAA AAA
3
5
Battery lamp
6 Battery compart-
ment on the rear
of the device
4
5