Bushnell TOUR V2 Manual Del Usuario página 5

liQuiD Crystal Display (lCD) inDiCators
Your TOUR V2 LCD incorporates illuminated indicators that advise the user unit of measure, when the
laser is actively firing, when a target has been acquired, and targeting modes. A summary of these
features is presented below:
UNIT OF MEASURE OPTIONS
The TOUR V2 can be used to measure distances in yards or meters. The unit of measure indicators are
located in the lower right portion of the LCD. To select between yards and meters, quickly press and
release the POWER button to turn on the unit (on top of the unit), look through the eyepiece, depress
the "MODE" button (left side of the eyepiece) and hold it down for approximately 5 seconds. If you are
changing from yards to meters, a change in unit of measure will be indicated by the illumination of the M
for meter indicator while the Y for Yard indicator is turned off. If you are changing from meters to yards,
the opposite will occur. The TOUR V2 will return to the last unit of measure setting used each time the
unit is turned on.
ACTIVE LASER
Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has
been acquired, you can release the power button. The crosshairs surrounding the circle will disappear
once the power button has been released (i.e. the laser is no longer being transmitted).
8
SELECTIVE TARGETING™ MODES
The TOUR V2 was especially designed with golfers in mind. The selective targeting modes allow you to
adjust the performance parameters of the unit to suit your specific situation and environment. To move
from one mode to another, press the POWER button once to turn on the unit. While looking through the
eyepiece, press the MODE button and quickly release. The different targeting modes available and mode
indicators are listed below:
Standard with Automatic SCAN (LCD Indicator – none)
most targets to be distanced up to 1000 yards. Used for moderately reflective
targets that are typical of most distancing situations. The minimum distance
in the standard mode is 5 yards. To use the Automatic SCAN feature, simply
hold down on the POWER button for approximately 3 seconds and move the
rangefinder from object to object while leaving the POWER button depressed.
Automatic SCAN will allow the range to be continuously updated as multiple
objects are targeted.
PinSeeker™ (LCD Indicator - ) Ever have trouble getting distance to the flag?
This advanced mode allows easy acquisition of the flag without inadvertently
getting distances to background targets (i.e. trees) that have stronger signal
strength.
This setting allows
9