PULOX PO-250 Manual De Instrucciones página 26

3) Put the patient's finger into the rubber cushions of the clip (make
sure the finger is in the right position), and then clip the finger.
4) Press the switch button once on front panel.
5) Do not shake the finger and keep the patient at ease during the
process.
6) The data can be read directly from the screen on the measuring
interface.
Fingernails and the luminescent tube should be on the same
side.
If the alarm function is on, the device will provide medium-
priority alarm signal when finger is out. Intermittent alarm will
occur and the user interface presents "FINGER OUT". Medium
priority indicating that prompt operator response is required.
B. Change display direction:
The display direction of the screen changes automatically according to
the handing direction.
C. Pause alarm
1. Alarm including the alarm of measure data's going beyond the
limits, the alarm of low-voltage, the alarm of finger's out of
position.
2. On the measuring interface, if the alarm function is on, during the
period of alarming, you can pause it by pressing the button shortly,
but the function will be renewed in about 30 seconds.
3. If you want to turn off the alarm permanently, you should enter
the menu for operation.
D. Data transmission setting
Firstly, please install the affiliated software on the computer, and two
icons will appear on the desktop after installation. The icon of "SpO2
Assistant" is the program for receiving real-time data and stored data
which is shown as Figure 5.
a) Please connect the device to the computer with the affiliated data
line , then double click the "SpO
and then click "Connect" to start the program.
b) When you close the "SpO
File" appearing on the desktop, in which you can input some
patient's basic information.
Figure 4 Finger Position
Assistant" icon and click "
2
Assistant", there is a dialog box "Save To
2
EN
"