Broan ERV200 ECM Guia De Instalacion página 7

4. M
AINTENANCE
4.2 A
NNUAL
Do not soak the energy recovery core in water. This core can easely be
damaged especially if it is soaked.
6. Clean the core (refer to table below).
H R
EAT ECOVERY
Allow the heat recovery core to soak for
3 hours in a solution of warm water and
mild soap (liquid soap).
Rinse lightly, let dry and reinstall.
7. Slide the cleaned core into the unit.
8. Slide the cleaned filters into the unit.
9. Close the unit door.
10. Clean the exterior hoods, then plug back the unit.
NOTE: The unit will return to its previous setting after a 30-second delay for booting
sequence.
11. Reset the Maintenance Indicator by pressing simultaneously on both
MODE and TURBO keys for 3 seconds on VT9W main wall control; this
will erase the maintenance icon from the screen.
( ' )
CONT D
M
(
AINTENANCE
CONT
C C
ORE LEANING
' )
D
CAUTION
E
NERGY
Remove the dust on the core using
a vacuum cleaner and a soft brush
attachment.
7
R C C
ECOVERY ORE LEANING
3 sec.
MODE
AND
TURBO