Troubleshooting - DeLonghi ECAM23210B Instrucciones Para El Uso

Ocultar thumbs Ver también para ECAM23210B:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Service.
PROBLEM
POSSIBLE CAUSE
The coffee is not hot
The cups were not preheated.
The infuser has cooled down because 2-3
minutes have elapsed since the last coffee
was made.
Low coffee temperature is set.
The coffee is thin or
not creamy enough.
The coffee is unsuitable.
The coffee is delivered
The coffee is ground too finely.
too slowly or a drop at
a time.
The spouts are blocked.
Coffee does not come
out of one of the
spouts.
The frothed milk has
The milk is not cold enough or is not semi-
skimmed.
large bubbles
Cappuccino maker is dirty
The milk is not frothed
Steam delivery stops
A safety device stops steam delivery after 3
minutes.
It is not plugged into the mains socket.
The appliance does not
come on.
The main switch is in O position.
The coffee is ground too coarsely.
21
REMEDY
Warm the cups by rinsing them with hot
function).
Before making the coffee, warm the infuser by
pressing the
button.
In the menu, set a high coffee temperature.
Turn the grinding adjustment knob one click
counter-clockwise towards "1" while the
coffee mill is in operation (fig. 10). Continue
one click at a time until coffee delivery is
satisfactory. The effect is only visible after
delivering two coffees (see "Adjusting coffee
mill", page 12).
Use pre-ground or coffee beans for espresso
coffee makers
Turn the grinding adjustment knob one click
clockwise towards "7" while the coffee mill is
in operation (fig. 10).
Continue one click at a time until coffee
delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see the section: "Adjusting the coffee
mill" on page 12).
Clean the spouts with a toothpick.
skimmed milk at refrigerator temperature
disappointing, try another brand of milk.
Clean as described in the section "Cleaning
the cappuccino maker after use" on page 31.
Wait, then activate the steam function again.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ecam23210sb

Tabla de contenido