Existing System Installation - Dell LSI21320-IS Guia De Inicio Rapido

Quick_Start_Guide_IS.book Page 21 Thursday, May 15, 2003 4:53 PM

Existing System Installation

This procedure installs or upgrades the SYMMPI.SYS driver onto an
existing Windows Server 2003 system. When the LSI21320 Dual Channel
Ultra320 SCSI to PCI-X host adapter is added to an existing system
installation, the new adapter is automatically detected at the next reboot.
When the Device Driver Wizard appears at boot, click the Next button
and continue at step 8 below.
To install the SYMMPI.SYS driver, follow these steps:
Click the Update Driver button to update the existing driver.
1
The Upgrade Device Driver Wizard begins.
Click the Next button.
2
Click the
3
"Display a list of know drivers..."
select it, then click the Next button.
Click the Have Disk button and type the path to the driver, or click
4
the Browse button. After the path to the driver has been established,
click the OK button.
Select the driver from the list and click the Next button.
5
Click the Next button again to start the driver update.
6
In some cases, a message will display saying that this driver is not
digitally signed. This message informs you that a non-signed driver is
being installed.
Click No to cancel the installation if the non-signed driver is not
7
desired.
or
Click Yes to continue the installation.
The system loads the driver from the Windows Server 2003 driver
diskette and copies the driver to the system disk.
For any adapter other than the boot adapter, the updated driver
becomes active immediately. For the boot adapter, a message box
displays indicating that you must reboot your system for the new
driver to take effect.
Click the Finish button to complete the driver upgrade.
8
button to
Integr ated Striping Quick Start Guide
21