Replacing The Oven Light - IKEA LAGAN Manual Del Usuario

Ocultar thumbs Ver también para LAGAN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN

replacing the Oven Light

CAUTION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light.
replacing the oven interior light bulb:
The interior oven light is located at the rear of the
oven cavity and covered with a glass shield. The
glass shield must be in place whenever the oven is
in use (Figure 21).
1. Turn electrical power off at the main source or
unplug the appliance.
2. Remove the interior oven light shield after re-
moving the wire holder by carefully moving the
wire to the side of the glass shield. The tension
from the wire holds the glass shield in place.
3. Pull the shield straight out. Do not twist or turn.
4. Replace the bulb with a new appliance bulb.
5. Replace the glass oven light shield. Replace wire
holder.
6. Turn the power back on again at the main source
(or plug the appliance back in).
7. Be sure to reset the time of day on the clock.
glass
shield
wire
holder
figure 21: Oven light protected by glass
shield
CArE AND CLEANING
removing the Storage Drawer
Use the storage drawer for storing cooking utensils.
The drawer can be removed to facilitate cleaning
under the range. Use care when handling the
drawer.
figure 22: Open storage drawer
figure 23: Closed storage drawer
Cleaning under bake element
The bake element is located in the lower oven cav-
ity. For some models, if the lower bake element is
visible it may be tilted up for easier access to the
oven bottom for cleaning. Remove the oven racks
before raising the element. Be careful not to raise
the element more than 4 or 5 inches from the rest-
ing position.
29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido