Remote Control Functions - Harman JBL Cruise X Guia De Inicio Rapido

REMOTE CONTROL MOUNTING AND
FUNCTIONS
Mounting surface
Flush mounting on the dash or console
1. Choose a mounting location within easy reach of the driver's
seat.
2. Drill a 25mm (1") hole in the mounting surface.
3. Remove the L-bracket from the remote assembly by
unscrewing the pressure-fit ring and sliding the bracket off.
4. Insert the remote into the pre-cut mounting surface. Secure
from behind by attaching the pressure-fit ring onto the back of
the remote housing. Do not overtighten.
5. Run the remote wire to the amplifier location along a protected
path that will not interfere with vehicle operation. Insert the
remote wire into the connector marked "remote" at the
amplifier pigtail wiring connector.
Tip: Use electrical tape to seal the connection between the
remote wire and the amplifier plug; this will protect it from the
elements.
EN
3
Flush mounting
Surface mounting on the dash or console
Surface mounting
1. Choose a mounting location within easy reach of the driver's
seat.
2. Use two sheet-metal screws; push through the holes on the
L-bracket and screw into mounting surface.
3. Run the remote wire to the amplifier location along a protected
path that will not interfere with vehicle operation. Insert the
remote wire into the connector marked "remote" at the
amplifier pigtail wiring connector.
Tip: Use electrical tape to seal the connection between the
remote wire and the amplifier plug; this will protect it from the
elements.

Remote control functions

Turn knob
Press button
Press and hold 3 seconds; you will hear an
Bluetooth
audible alert once in pairing mode, select JBL
pairing
Cruise X on your Bluetooth device
Volume up Turn knob to the right for up, and to the left for
and down down
Press the button once to pause the music;
Play/pause
press again to play
Double-press the button quickly to select the
Track up
next track
Triple-press the button quickly to select the
Track back
previous track