Bluetooth Pairing - Harman JBL Cruise X Guia De Inicio Rapido

BLUETOOTH PAIRING

1. Pair your Bluetooth device:
• Press and hold 3 seconds. You will hear an audible alert and
the blue LED ring at the base of the remote is flashing to
indicate pairing mode.
• Once in pairing mode, select JBL Cruise X on your Bluetooth
device.
• A solid blue LED ring at the base of the remote indicates that
your Bluetooth device has successfully paired with the JBL
Cruise X.
NOTE: The JBL Cruise X features an attenuation selector
switch for the rear speakers on the amplifier control panel. Once
you have paired your Bluetooth device, play music and listen
at normal volume levels of front and rear speakers. If the rear
speakers sound too loud relative to the front speakers, apply
-3dB or -6dB of attenuation to the rear speakers using the
selector switch on the amplifier end panel.
REAR SPEAKERS
-3dB -6dB
0
PHONE CHARGING, EXTRA SOURCES, AND
ADDING EXTRA SPEAKERS
The JBL Cruise X features additional wire connections to make
installation as flexible as possible, and to allow you to add extra
sources and functionality:
1. A USB input with 5V/1A charging for connecting and charging
your Bluetooth device.
2. An RCA AUX Output allows you to use the JBL Cruise X as
the primary audio source while plugging in additional powered
speakers, or powered subwoofer, using RCA patch cables.
A remote output wire enables auto turn-on of the powered
accessory product/s.
3. An RCA AUX Input allows you to use the JBL Cruise X as a
powered speaker system while plugging in the audio signal
from an external source, such as a head unit or JBL sound
bar using RCA patch cables.
®
Note: Bluetooth audio playback will automatically take priority
over playback from a source connected to the AUX inputs. The
AUX input will play automatically if Bluetooth
audio signal is present. The USB input is for charging only, and
does not support audio playback.
SPECIFICATIONS
®
is paused or no
Speaker size
Interconnect speaker wire length
Remote control wire length
RMS Power Output (Watts x
Channel)
Battery Voltage Range (Volts)
Turn-on Mode
Amplifier LED Indicator (at
amplifier)
Bluetooth LED Indicator (at
remote)
Frequency Response, +/- 1dB
Input Sensitivity - Low Level
Fuse Rating
USB Charging
Auxiliary Inputs
Pre-Amp Outputs
Protection
Bluetooth version:
Bluetooth profile:
Bluetooth transmitter frequency
range:
Bluetooth maximum transmitter
power:
Bluetooth transmitter modulation:
3 inches (75mm)
9.5 feet (2.9 meters)
8 feet (2.43 meters)
20W x 4
8V to 17V
12V
Red/Green
Blue
120Hz to 20kHz
400mV to 2V
10A
5V (1A)
RCA
RCA
DC, OVP, UVP, OCP,
OTP
4.2
A2DP V1.3,
AVRCP V1.6
2402 – 2480 MHz
10 dBm (EIRP)
GFSK, π/4 DQPSK,
8DPSK
EN
4