Electrical Connection - Femi TR240 Instrucciones De Uso Y Mantenimiento

DANGER - CAUTION
Machine positioning in the work area must ensure that there is a clearance of at
least 800 mm on all sides of the machine (see Fig. 4).
c. Position the machine in a work area with adequate lighting.
2.5.

ELECTRICAL CONNECTION

Safety Standards for electrical connections
- Check that the mains system to which the machine is to be connected is earthed in
accordance with the relative safety regulations in force.
DANGER - WARNING
CHECK THAT THE POWER SUPPLY SYSTEM IS EQUIPPED WITH A THERMOMAGNETIC
CIRCUIT BREAKER TO PROTECT ALL CONDUCTORS FROM SHORT CIRCUIT AND
OVERLOADS (SEE APPENDIX).
Preliminary tests and checks after connection
DANGER - WARNING
- BEFORE CONNECTING THE MACHINE TO THE MAINS, CHECK THAT THE SUPPLY
VOLTAGE MATCHES THE VOLTAGE INDICATED ON THE MACHINE ITSELF.
- ONCE CONNECTED, TO AVOID ANY POSSIBLE RESIDUAL RISKS OF TRIPPING
AND FALLING, MAKE SURE THAT THE POWER SUPPLY CABLE LIES
COMPLETELY ON THE GROUND AND IS NOT AT ANY POINT RAISED IN THE
AIR.
Specific characteristics of the electrical system
DANGER - WARNING
- THE MITRE SAW'S ELECTRICAL SYSTEM IS FITTED WITH AN UNDER-VOLTAGE
RELAY WHICH AUTOMATICALLY OPENS THE CIRCUIT IF THE VOLTAGE DROPS
BELOW A MINIMUM SET LIMIT AND INHIBITS AUTOMATIC RESET OF OPERATING
CONDITIONS WHEN THE VOLTAGE RETURNS TO THE SET RATED LEVELS.
- SHOULD THE MACHINE SUDDENLY CUT OUT THERE IS NO CAUSE FOR ALARM.
CHECK THAT THERE HAS NOT BEEN A VOLTAGE FAILURE IN THE MAINS
SUPPLY.
EN
31