Environmental Protection; Electrical Connections; Extension Leads; Machine Description (Fig. 2-3) - Femi D 305 Manual Del Usuario

ENVIRONMENTAL PROTECTION

INFORMATION FOR USERS
Implementation of Directives 2011/65/EU,
2012/19/EU, relative to reducing the use of
hazardous substances in electric and electronic
appliances and the disposal of waste", please
take note of the following:
• The crossed out wheelie bin symbol found on the
appliance or the packaging indicates that the product
must be disposed separately from ordinary household
waste when it reaches the end of its working life.
• The user must consign the unwanted appliance to
an authorised waste disposal centre for electric and
electronic goods, or alternatively, hand it over to the
relative dealer at the moment of purchasing a new
appliance of the same type on a basis of a one to one
ratio.
• Diff erentiated disposal to enable possible recycling or
environmentally compatible elimination of the appliance,
helps to limit undesirable effects on health and
environment and promotes the reuse and/or recycling
of the materials that compose the appliance.
WARNING!
In accordance with the relative legislation in force
in the country of use, sanctions will be imposed on
the user if the appliance is disposed of illegally.

ELECTRICAL CONNECTIONS

ELECTRICAL CONNECTIONS
Use 230 V 50 Hz alternate voltage to supply your machine.
Ensure that the power supply corresponds to this voltage, that
it is protected by a diff erential and magnetothermal switch,
and that the earthing system is effi cient. If your machine does
not work when connected to a socket, check carefully the
power supply features.

EXTENSION LEADS

Only use three conductors extension cables, with a plug
with two plugs and a earthing contact and sockets with two
holes and a earth corresponding to the plug of the tool. When
using an electric tool at a remarkable distance from the power
supply, use an extension lead with suffi cient dimensions to
transport the current which the tool needs. If the extension
lead has not the suffi cient dimensions a voltage drop can
occur, thus causing an overheating and a voltage loss. You
can only use extension leads which are in compliance with
CE standards.
Extension lead length: ........................................up to 15 m
Cable dimensions: ...........................................3 x 2,5 mm²
Before using any kind of extension lead, check that it has not
bare wires and that the insulation is not cut or worn. Repair
and change immediately it if it is damaged or worn.
WARNING:
Extension leads must be arranged away from the
working area in order that they do not come into
contact with the workpieces, the tool or other parts
of the machine, thus creating possible risks.
WARNING:
KEEP THE TOOLS AND THE EQUIPMENT AT A
SAFE DISTANCE FROM CHILDREN
WARNING:
Your mitre-saw's electrical system is equipped
with an undervoltage relay which automatically
opens the circuit when the voltage falls below a
minimum pre-established limit and which prevents
the self-reset of the machine functions when
voltage returns to normal levels. If the machine
stops involuntarily, do not be alarmed and make
sure that there has not been a voltage failure in the
electrical system.

MACHINE DESCRIPTION (Fig. 2-3)

The mitre-saw machine consists of three basic parts: the
machine body complete with motor 6, which is integrated into
the base 3 by means of the joint 4 and the swivel support 5,
and the upper work unit, consisting of the workbench 12, the
rest square 14 and the movable protective cap 13.
The base 3 is used as a support when cutting and butting
operations have to be carried out in the diff erent available
angles; the upper table is used as a support when trimming
or sectioning large planks of wood, and especially when
cutting wood along the grain.
EN
17