Installing - Axxess AX-ADGM100 Manual Del Usuario

12-way harness:
This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1 instructions
for programming.
1. With all the connections completed, plug the 24, 22, and 12-pin
harnesses into the AX-ADGM100.
2. Plug the 24 and 12-pin GM harness into the vehicle side harness, and
plug the aftermarket radio harness into the aftermarket radio.
3. Reconnect the negative battery terminal.
Cycle the key by turning the ignition on for 30 seconds, then back off, then back on
again to test the radio.
OE Satellite Radio & Rear Seat Entertainment (if equipped):
Note: (1) The vehicle must have a "Source" button on the steering wheel in order to
retain these features.
(2) The rear seat entertainment must be activated by the OE radio. If a power button
somewhere else in the car turns the rear seat entertainment "on", this interface will
not operate the rear seat entertainment.
Continues on next paragraph.
AX-ADGM100
Installing the AX-ADGM100
13
• To listen to the audio from the satellite radio or rear seat entertainment,
change the source of the radio to AUX.
• The AX-ADGM100 can retain both satellite radio and rear seat
entertainment. Satellite radio audio is "on" by default. To toggle rear seat
entertainment audio "on", press and hold the "Source" button on the
steering wheel for 1.5 seconds. To toggle Satellite radio audio back "on"
press and hold the "Source" button again for 1.5 seconds. Also, in order
to use the satellite radio, the optional AX-LCD screen is recommended as
without the AX-LCD screen, you will not be able to see any information
pertaining to the satellite radio like which station you are viewing. The
satellite radio will still function even without the AX-LCD.