Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. From the 30-way harness:
•
Connect the Black wire to the ground wire of the aftermarket radio.
•
Connect the RCA to the AUX-in on the aftermarket radio (if equipped) to
retain RSE and/or OE satellite.
•
Satellite information will be displayed on driver information center (DIC).
•
Connect the Yellow wire to the constant wire of the aftermarket radio.
•
If the vehicle is amplified disconnect the 4-pin harness located between
the 30-way and 22-way connector and connect the supplied 4-pin to 4-pin
resistor pad.
For amplified systems:
•
Connect the Violet wire to the right rear positive wire of the
aftermarket radio.
•
Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
•
Connect the Green wire to the left rear positive wire of the
aftermarket radio.
Connect the Green/Black wire to the left rear negative wire of the
•
aftermarket radio.
For non-amplified systems:
•
Cut the resistors from the Green, Green/Black, Purple, Purple/Black right
below the heat shrink.
•
Connect the Violet wire to the right rear positive wire of the aftermarket radio.
Continues on next paragraph.
AX-ADGM100
Connections to be made
12-way harness:
This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1
instructions for programming.
9
•
Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
Connect the Green wire to the left rear positive wire of the
•
aftermarket radio.
•
Connect the Green/Black wire to the left rear negative wire of the
aftermarket radio.
•
Connect the DIN plug to the optional AX-LCD screen if satellite radio is
to be retained.
Installing the AX-ADGM100
1.
With all the connections completed, plug the 16 and 22-pin harnesses into
the AX-ADGM100.
2.
Plug the 30-pin GM harness into the vehicle side harness, and plug the
aftermarket radio harness into the aftermarket radio.
3.
Reconnect the negative battery terminal.
4.
Initialize the interface by cycling the key by (1) turning the ignition "on" for
30 seconds, (2) then back off, and then (3) back on again to test the radio.
Continued next page
Publicidad
Capítulos
Tabla de contenido
