Connections To Be Made; Into The Vehicle; To The Radio - Axxess AXSWC-TL Instrucciones De Instalación

Into the vehicle

With the key in the off position:
1. Connect the Black wire of the AXSWC-TL to ground.
2. Connect the (2) Red wires of the AXSWC-TL to accessory power.
3. For all vehicles EXCEPT the Lexus SC430, connect ONLY the 12-pin connector to the
mating connector in the vehicle. The 6-pin connector on the AXSWC-TL harness WILL
NOT be used in the application.
4. For the 2002-2005 Lexus SC430, connect ONLY the 6-pin connector to the mating
connector in the vehicle. The 12-pin connector on the AXSWC-TL harness WILL NOT
be used in the application.
Note: Disregard the 12-pin connector in the vehicle.
5. For the 2006-2009 Lexus SC430, connect BOTH the 6-pin and 12-pin connectors to
the mating connectors in the vehicle.

To the radio

1. For the radios below, connect the included female 3.5mm connector with the Brown
and Brown/White wires into the male 3.5mm connector of the AXSWC-TL harness.
• For Eclipse radios: Connect the Eclipse steering wheel control wires (normally
Brown and Brown/Black) to the Brown and Brown/White wires of the AXSWC-TL.
Brown of the AXSWC-TL goes to the Brown/Black of the Eclipse and Brown/White
of the AXSWC-TL goes to the Brown of the Eclipse.
2

CONNECTIONS TO BE MADE

2. For Parrot Asteroid Smart or Tablet: Connect the AXSWC-TL male 3.5mm jack into
3. For XITE radios: Connect the steering wheel control SWC-2 wire from the radio to
4. For all other radios: Connect the 3.5mm jack of the AXSWC-TL into the jack on the
• For Metra OE: Connect the SWC Key 1 wire (Gray) to the Brown wire of the
AXSWC-TL. Isolate and tape the Brown/White wire, it will not be used.
• For Kenwood or select JVC's with a Blue/Yellow steering wheel control wire:
Connect the Kenwood/JVC steering wheel control wire to the Brown wire of the
AXSWC-TL. Isolate and tape the Brown/White wire, it will not be used.
Note: Some of the newer Kenwood radios will auto detect as a JVC. If this is
the case, use a 12k ohm resistor in line between the Blue/Yellow and Brown
wire of the female 3.5mm jack during programming only (remove resistor once
programmed).
the AXSWCH-PAR (sold separately) female 3.5mm jack and plug the 4-pin end into
the corresponding SWC plug on the radio.
Note: AXSWCH-PAR required (sold separately) and radio MUST BE updated to rev
2.1.4 or higher.
the Brown wire of the AXSWC-TL.
aftermarket radio designated for an external steering wheel control interface.
Please refer to the aftermarket radios manual if in doubt as to where the 3.5mm
jack goes into.