Skoda ABA 700 002 Instrucciones De Montaje página 19

Deep tone speaker (2-pole terminal board (G) - post type)
- Left side of the vehicle
- blue/white cable (of harness E) - PIN 1
- brown/white cable (of harness E) - PIN 2
- Right side of the vehicle
GB
- red/green cable (of harness E) - PIN 1
- brown/green cable (of harness E) - PIN 2
- Connect the fitted terminal boxes (F) and (G) into the corresponding terminal boxes of the
speakers.
Fasten the harness of electric installation (D) in the door using fasteners (L).
For the Škoda Fabia (5J) vehicles, adapt excessive length of the electric installation har-
ness (C) in loop, as shown on Fig. 5. Put the loop under the carpet and fasten it with
a suitable adhesive tape, if needed. Make sure the cables of the harness cannot be
damaged by the carpet fasteners.
Fix the harnesses of electric installation of the rear speakers on suitable spots with
the help of contracting bands (K), so that they cannot be damaged and that no vibra-
tions or disturbing noises are produced during the drive in the car interior, but at each
20 centimetres at most.
Re-fit all the removed parts (change defective clamps, if needed). Connect the car battery and
perform all operations related with the disconnection and re-connection of the car battery.
Encode the original car radio for operation with front and rear speakers with the help of a
diagnostic tool.
Check the right setting of flexible bushings in the pillars and in the doors, so that no
water can penetrate into the car.
Test the speaker function.