Car Radio - Skoda ABA 700 002 Instrucciones De Montaje

- 2 -
- Scheme of pulling through the harness of electric installation.
- 3 -
- Snap the high tone speaker (B) into the hole in the door panel.
GB
- 4 -
- Set the deep tone speaker (A) into correct position and fix it with the help of rivets (H) in the
rear door opening.
Connection of harnesses of electric installation of rear speakers
Pass all harnesses of electric installation of the rear speakers according to figure 2.
- 5 -
- Lead the electric installation harness (C) from the rear seats under the carpet and then along
the central tunnel on its left side (around the elbow rest console, hand brake and the speed
lever console) to the front, up to the metal-plate console of the dashboard. Then along the
existing electric installation harness of the vehicle to the hole for the car radio (see Fig. 8).
Advice. Lead the harness in the same way for the right hand drive, but on the right side of
the tunnel.
- If the elbow rest is not included in the equipment of the vehicle, use the tightening tape with
fastener (M) to fasten the electric installation harness.
- Locate the diverging of conductors in the electric installation harness (for the left and
right side of the vehicle) approximately to the point of cut-out in the carpet of the
car.
- Left side of the vehicle (in the travel direction) - blue/white cable, brown/white
cable.
- Right side of the vehicle (in the travel direction) - red/green cable, brown/green
cable.
- 6, 7 -
- Lead a part of the electric installation harness (C) blue/white cable and brown/white
cable as shown on Fig. 5 under the carpet to the left side of the vehicle to the B-pillar.
Then along the existing electric installation of the vehicle downwards to the hole for flexible
foor bushing. (Lead the other part of the electric installation harness (C) red/green cable,
brown/green cable in the same way to the right side of the vehicle).
- Pull the harness of electric installation (D) throuh the door bushing.
Advice. For Fabia (5J) and Fabia Combi (5J) vehicles ensure correct positioning of the electric
installation harness (D) in the area of the door (Fig. 7).
- 9 -
- Connect the harness cables in the following way.

Car radio

- Original car radio (terminal box T8d)
- blue/white cable (of harness C) - PIN 4