Taurus PTCP-2200 Manuel De Instrucciones página 7

control (E) which when set to the MIN position
allows dry ironing (no steam).
Steam Ironing:
- It is possible to iron with steam whenever the
deposit is filled with water and the adequate
temperature is selected.
Steam flow control:
- The appliance has a steam and temperature
control (E) used to regulate the steam flow.
Vertical steaming
It is possible to iron hanging curtains, items of
clothing on his hanger, etc. To do so, follow the
instructions:
Select the maximum temperature of the iron,
while turning the temperature regulator of the iron
in a clockwise direction.
- Move the iron in a top to bottom direction while
pressing the steam control ( C ). Important: for
cotton and linen, its recommended to put the iron
base in contact with the material. For other more
delicated fibres, it's recommended to keep the
iron base at some centimetres of distance.
Once you have finished using the appliance:
- Select the minimum position (MIN) using the
steam and temperature control.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
Cleaning
Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
Quick cleaning guide:
1) Fill the tank with approximately 1 litre of water.
(Do not put vinegar or other descaling agents into
the water tank)
2) Plug in the ironing system and set the tempera-
ture control to MIN.
3) Hold the iron vertically over the sink and press
the steam button (C) for 1 minute to pump the
water from the tank to the iron.
4) Increase the iron's temperature setting to
number 2
5) Place the iron horizontally over the sink, keep
pressing the steam button (C) and gently rock the
iron backwards and forwards for 1 minute.
6) Unplug the ironing system from the mains
supply and immediately rub the soleplate with a
damp cotton cloth folded several times. (Never
use scouring pads or chemicals).
* Repeat the cleaning process at least twice.
** We recommend performing the process once
a month to prolong the service life of the ironing
system. If the water in your area is very hard or
you notice limescale coming out through the sole-
plate during ironing, use this function more often.