Troubleshooting; Declaration Of Conformity - STEINEL Studioline 400 Instrucciones De Montaje

L400_10spr.qxd 31.07.2008

Troubleshooting

Malfunction
Sensor light fixture
without power
Sensor light fixture
does not switch on
Sensor light fixture
does not switch off
Sensor light fixture
keeps switching on and off
Sensor light fixture switches
on when it should not
Range of sensor light fixture
changes

Declaration of conformity

This product is in confor-
mity with standards of low
voltage in accordance with
12
13:51 Uhr Seite 13
Cause Remedy
y Fuse has blown; not y Replace fuse; switch on
switched on; break in
wiring
y Short-circuit y Check connections
y Lighting controller set to y Adjust setting
nighttime mode during
daytime operation
y Bulb burned out y Replace light bulb
y Power switch off y Switch on
y Fuse blown y Replace fuse, check
y Detection zone not y Recalibrate
properly targeted
y Internal circuit-breaker y Switch SensorLamp off
has opened
y Continuing movement in y Check detection zone
monitoring zone
y Set to continuous opera- y Switch multi-circuit
tion by indoor multi-
circuit switch
y Animals moving in detec- y Tilt sensor higher;
tion zone
y Wind is moving trees or y Change detection zone
bushes in detection zone
y Cars in the street are
y Change detection zone,
being detected
y Sunlight is striking the
y Install sensor in shel-
lens
y Reflection from light- y Re-adjust lighting con-
colored walls or pave-
ments
y Sudden temperature y Change detection zone
changes due to weather
(wind, rain, snow) or
exhaust air from fans or
open windows
y Differing ambient tempe- y When it is cold, shorten
ratures
y When it is hot, tilt sensor
the regulations 73/23/EEC,
89/336/EEC.
power switch; check wir-
ing with voltage tester
connection if necessary
and then on again
and recalibrate if
necessary
switch to automatic
change detection zone
tilt sensor down
tered spot, or change
detection zone
troller
or install at different spot
range by tilting sensor
down
up