Kohler K-18486 Manual Del Usuario página 6

Subfloor
Wood Screw
5-29/32"
(15 cm)
Riser
Support
22"
(55.9 cm)
2. Prepare the Site - Freestanding
Mark the location of the water supply lines from the bath drain.
Use the template provided with the riser tubes to assist you.
Verify the distance between the centerline of the marked holes is
5-29/32" (15 cm) and the distance between the centerline of each
marked hole to the centerline of the drain outlet is 22" (55.9 cm).
Drill the marked holes using a 1-5/8" spade drill bit or hole saw.
Insert the riser support through the drilled holes.
Secure the riser support to the subfloor with eight wood screws
(provided).
NOTE: To protect the riser support from debris when installing the
finished floor, position the supplied thread protectors in the holes of
the riser support.
Install the 1/2" water supply tubing.
Install the finished floor material.
Measure and mark 20-11/16" (52.5 cm) up from the surface of the
finished floor onto the water supply tubes. Cut the water supplies
tubes to this height.
IMPORTANT! The dimensions reference a nominal height of
22-1/4" (56.5 cm) from the finished floor to the center of the
predrilled pilot hole in the freestanding bath (see "Construct the Tee
1054455-2-E
Male Copper
Connections
Water Supply
Tubing
Drain
Outlet
6
21-9/16"
(54.8 cm)
Finished
Floor
20-11/16"
(52.5 cm)
Kohler Co.