Kohler K-18486 Manual Del Usuario página 9

Bracket
Tee Rod
Tee
4. Construct the Tee Assembly - Freestanding
Thread the fastener support into the side of the bath with a 1/4"
hex wrench. Do not overtighten.
Ensure the distance from the head of the fastener support to the
bath surface is approximately 1/2" (1.3 cm).
Thread the fastener rod into the fastener support.
Thread a bracket onto one end of tee rod until hand-tight.
Slide the tee rod through the center hole of the tee.
Hand tighten the remaining bracket onto the other end of the tee
rod to construct the tee assembly.
Ensure the center-to-center distance between the brackets aligns
with the center-to-center distance of the installed riser tubes.
Slide the tee assembly down onto the installed riser tubes. Do not
secure the tee assembly at this time.
Kohler Co.
Fastener
Rod
Fastener
Rod
Fastener Support
9
1/2"
(1.3 cm)
Bath
Fastener
Support
1054455-2-E