Chevrolet Performance 84099784 Manual Del Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If your car is equipped with the Heavy Duty Cooling and Brake Package (Regular Production Option (RPO): Y4Q (KC4
– External Engine Cooler)), ensure there is clearance between the External Engine Cooler (circled below) and the Air
Cleaner Outlet Duct Coupler & Clamps. Adjust Air Induction System as necessary to ensure clearance (approximately ¼"
minimum).
Re-clip Air Cleaner Resonator Tube to bottom of the Air Cleaner Outlet Duct.
Re-clip PCV breather hose to the passenger side Air Cleaner Outlet Duct. Re-seat and tighten PCV breather hose clamp
(8 mm) to driver's side of Air Cleaner Outlet duct and torque to 4.0 Nm (35 lb-in).
Mark position of and then remove production MAF Sensor Wire Retaining Clip with Wire Snip Pliers. Caution: Ensure you
do not cut or damage the MAF Sensor Wiring. Doing so could cause poor engine operation and drivability leading to Check
Engine Light illumination.
Attach Wire Harness Retaining Clip provided in the kit at the marked place on the MAF Wire Harness. Remove excess zip
tie material with Wire Snip Pliers.
Press MAF Sensor Wire Clip into Performance Air Box Wire Clip mounting provision. Plug in MAF Sensor Electrical
Connector and push down positive lock once seated.
Chevrolet Performance Air Induction Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84099784
REV 22FE17
PART NO.
DATE
26SE16
Initial Release - Benjamin Kaminsky
22FE17
Revision - Benjamin Kaminsky
11
SHEET
REVISION
36
OF
AUTH
2545956
2642462

Publicidad

Tabla de contenido
loading

Tabla de contenido