•
Remove inside foam support piece from Air Box Inlet Gasket. Peel off adhesive protective backing from Air Box Inlet
Gasket.
•
Adhere Air Box Inlet Gasket to mating surface on rubber Air Box Assembly Inlet Mating Duct Surface behind driver's
side headlight on vehicle. Caution: Be careful not to overstretch or bunch inlet gasket beyond the rubber inlet duct flat
surface. Doing so could result improper sealing of the air box inlet.
•
Ensure rubber grommets from Production Air Cleaner Assembly are properly seated in vehicle mounting points. Seat
Performance Air Box assembly into mounting grommets while ensuring Air Box Inlet Gasket seals well with the Air Box
Inlet Flange. Check that the Air Box Hood Seal is seated properly on the Air Box.
Chevrolet Performance Air Induction Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
X
REV 22FE17
26SE16
22FE17
84099784
PART NO.
DATE
Initial Release - Benjamin Kaminsky
Revision - Benjamin Kaminsky
8
SHEET
REVISION
36
OF
AUTH
2545956
2642462