Publicidad
PROBLEM
Cleaner won't run
Low suction
Hose Nozzle stops spraying liquid during use
Accessory Tool will not spray after filling the
Clean Water Tank or Solution Tank
Hose will not spray after priming pump
Clean water won't dispense
Solution won't dispense
Brushes won't rotate during floor cleaning
Water is leaking out of Carpet Cleaner
Spot Chaser Pretreat Wand will not dispense
22
POSSIBLE CAUSE
1. Not firmly plugged in
2. No voltage in wall plug
3. Blown fuse or tripped breaker
4. Fuse in cleaner blown
5. On/Off pedal not depressed
1. Dirty Water Tank full/automatic shut off engaged
2. Blockage in tool on end of hose
3. Dirty Water Lid not on correctly
4. Dirty Water Tank Debris Filter clogged
5. Blockage in Nozzle
6. Dirty Water Tank not properly secured
7. Dirty Water Nozzle not on correctly
8. Blockage in hose
1. Clean Water Tank or Detergent Container is empty
2. Loose connection to solution port on foot of cleaner
1. Air is trapped in the hose & pump
1. Pump is defective
2. Not connected properly
1. Clean Water Tank or Solution Tank not firmly in place
2. Clean Water Tank or Solution Tank empty
1. Cleaner is not moving in forward direction
1. Brushroll stall protection activated
2. Unit in upright position
1. Clean Water Tank, Solution Tank or Dirty Water Tank not FIRMLY in place
1. Batteries installed incorrectly or need to be replaced. Spray will start to
lessen as the battery gets close to dead.
2. Spray tip clogged
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
4. Take to service center.
5. Press pedal.
1. Remove and empty Dirty Water Tank. See "How to Empty" page 13.
2. Remove tool and clear blockage.
3. Make sure lid is on securely. See "How to Empty" page 13.
4. See "How to Clean" page 13.
5. See "How to Clean" page 15.
6. Replace Dirty Water Tank and secure Dirty Water Tank latch.
7. Remove and replace Dirty Water Nozzle. See "How to Clean & Remove Nozzle" page 15.
8. Drop a coin through, clear with broom handle.
1. Turn off Cleaner and fill Clean Water Tank & Detergent Container.
2. Check for secure connection to solution port on body of Cleaner.
1. Turn on the Cleaner. If hose does not spray, prime the pump by lowering the hose down to the floor and hold the trigger
for up to one minute.
2. Aim downward & squeeze trigger.
1. Call for service: 1-800-944-9200.
2. Check connection.
1. Make sure tank is securely locked in position.
2. Refill container according to cleaning instructions.
1. Must be moving the machine forward to properly dispense water and solution.
1. Turn the unit off and back on, then inspect and clean for jams.
2. Brushes will not rotate in upright position. Step on handle release to start cleaning.
1. Make sure the tank is secure.
2. Carpet Cleaner may drip residual moisture after use. Allow cleaner and brushes to dry before storing on hard floor surface.
1. "How to use Spot Chaser Pretreat Wand" page 19
Publicidad
