HOLZMANN MASCHINEN VD 1100ECO Instrucciones De Servicio página 29

17 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Strong vibration
Bad turning result
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defective
 Circuit breaker is active
 Warped workpiece
 Workpiece is wrong centered
 Loosen pulley
 Outworn pulley
 Turning lathe is on uneven surface
 Loosen tail- or headstock
 Too much speed
 bad sharpened chisel
 Wrong chisel for this work
 Wrong adjustment of tool rest
www.holzmann-maschinen.at
Solution
 Repair switch
 Repair power supply
 Change fuse
 Push in the circuit button
 Change material
 Measure the center newly
 Tighten the pulley
 Change pulley
 Level the surface
 Tighten
 Adjust speed
 Sharpen the chisel
 Select the right chisel
 Adjust the high and the
distance of the tool rest
NOTICE
MAINTENANCE
29
VD 1100ECO