Satco NUVO 65-231 Instrucciones De Instalación Y Seguridad

LED WALL PACK FIXTURES
Models: 65-231, 65-232, 65-233, 65-234, 65-235, 65-236,
65-237, 65-238, 65-239, 65-240, 65-241, 65-242
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To reduce the risk of fire, electrical shock or injury to persons; read and follow all warnings
and installation instructions before installing.
• All installation should be performed by a qualified electrician.
• To avoid electric shock, ensure power is turned off before installation or inspection.
All wiring must be installed in accordance with Electrical Code and local electrical code.
• To prevent fire, this fixture is rated for use in 120-277V, 50-60Hz protected circuit and
90°C rated supply wire.
• To prevent product malfunction and/or electrical shock, this product must be properly
grounded.
• To avoid damage and/or product malfunction, do not modify the fixture or replace
accessories without confirming with the supplier first.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Suitable for wet locations.
IMPORTANT:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the product and the hazards involved.
INSTALLATION:
STEP 1: Open the fixture with the
hex wrench.
STEP 2: Disconnect the wire from
part A and B.
STEP 3: Separate part A and B
and set part A aside.
STEP 4: Prepare the back plate for
mounting by drilling or knocking
out the appropriate holes.
STEP 5: Thread the input wire
through the gasket, then the hole
of part B.
STEP 6: Connect the wire with
power input line by 3 connectors,
refer to wiring diagram. (L = Black,
N = White, G = Yellow/Green, keep
the circuit open during the process).
STEP 7: Put part A back onto the
hinge of part B. Check the hinge is
secured.
STEP 8: Reconnect the wire from
part A to part B. Close the fixture
and tighten with the hex wrench.
SENSOR INSTALLATION:
Remove motion sensor board and
secure sensor head onto the motion
sensor board. Secure motion sensor
board back to LED board and connect
sensor head to sensor body.
© Copyright 2019 Satco Products, Inc. 1/19
1 2
4 5
A
7
B
Motion Sensor Body
Motion Sensor Board
Parts Included
Wallpack Fixture
EVA Gasket
A
B
Connector x 3
Wall
B
EVA Gasket
8
L = Black
N = White
G = Yellow/Green
(Dimming wire not
needed to connect)
Quantity
1
1
A
3
B
6 1.4"
0.24"– 0.32"
WIRING DIAGRAM
Light Fixture
DIM +
DIM –
Satco Products, Inc.
Brentwood, NY 11717