Satco NUVO 65-265 Instrucciones De Instalación Y Seguridad

SMALL LED WALL PACK
WITH PHOTOCELL
Models: 65-265, 65-266, 65-267, 65-268, 65-269, 65-270
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To reduce the risk of fire, electrical shock or injury to persons; read and follow all warnings
and installation instructions before installing.
• All installation should be performed by a qualified electrician.
• To avoid electric shock, ensure power is turned off before installation or inspection.
All wiring must be installed in accordance with Electrical Code and local electrical code.
• To prevent fire, this fixture is rated for use in 100-277V, 50-60Hz protected circuit and
minimum 75°C rated supply conductor.
• To prevent product malfunction and/or electrical shock, this product must be properly
grounded.
• To avoid damage and/or product malfunction, do not modify the fixture or replace
accessories without confirming with the supplier first.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Suitable for indoor/outdoor applications.
IMPORTANT:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the product and the hazards involved.
INSTALLATION: A
STEP 1: Turn off power before installation,
then loosen the 4 screws on the fixture.
STEP 2: Remove the 1/2 end cap.
STEP 3: Peel off the yellow sticker and paste it
on the round area of the bottom plate..
STEP 4: Fix the bottom plate on the round plate.
STEP 5: Connect the wire with power input line
by 3 connectors, refer to wiring diagram.
(L = Black, N = White, G = Yellow/Green).
STEP 6: Reconnect the fixture and tighten
with the screws.
INSTALLATION: B
Follow STEP 1 from installation A (see above).
STEP 2: Paste the black sponge pad on the
bottom plate.
STEP 3: Screw the bottom plate on the wall.
STEP 4: Remove one of the 1/2 end cap and
thread through the wire.
STEP 5: Connect the wire with power input
line by 3 connectors, refer to wiring diagram.
(L = Black, N = White, G = Yellow/Green).
STEP 6: Reconnect the fixture and tighten
with the screws.
© Copyright 2019 Satco Products, Inc. 2/19
1
4
2 3
5
Dimensions
147mmW x 218mmH x 78mmD
2 3
5
4
WIRING DIAGRAM
L = Black
N = White
G = Yellow/Green
Light Fixture
DIM +
DIM –
(Dimming wire not
needed to connect)
Satco Products, Inc.
Brentwood, NY 11717