Beurer UWB 55 Manual Del Usuario página 8

2. Spread the underblanket out onto your mattress, starting at the
foot end, with the connector toward the head. Leave enough room
at the head end for your pillow.
3. Attach the securing straps as shown. Start by attaching the
first strap to the middle side loop of the underblanket, route it
underneath the mattress, and then connect the other end to the
other middle side loop on the underblanket (Fig. 1).
4. Attach the second strap to the lower side loop, then route the strap
under the corner of the mattress and back up to the loop in the
bottom center as shown in Fig. 2.
5. Then feed it through the loop in the middle of the foot end. Route
the strap back under the other bottom corner of the mattress and
back up again to the other bottom side loop as shown in Fig. 3.
6. Attach the third strap at the head end of the underblanket like the
bottom end strap, routing it under the corners of the mattress and
through the middle top loop as shown in Fig. 4.
7. Place your sheets and other bedding over the pad onto your
mattress as normal.
NOTICE
• The heated underblanket may smell of plastic the first time you use it, but this will disappear after a
short period of time.
Switching On
Switch the electric underblanket on about 30 minutes before going to bed and cover it with the top sheet
and other bedding. By doing this you will keep all the heat in.
Push ON/OFF shift button to ON. The electric underblanket will come at a default setting of temperature
level 8 and 10 H timer. The LED for timer and temperature will be illuminated.
WARNING
• Do not fall asleep with the underblanket set to heat level 8.
NOTICE
• This underblanket features rapid heating, which allows it to heat up within the first 10 minutes of operation.
8