Parts And Controls; Intended Use; To Use - Beurer UWB 55 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3� Parts and Controls
1. Controller
2. Heated Underblanket
3. Mains plug
4. Cord
5. Control Connector
6. ON/OFF shift button
7. Heat setting
8. Timer
4� Intended Use
This heated underblanket is designed for warming beds only. This underblanket is not intended for medical
purposes. It is not suitable for use in hospitals or for any other commercial use. In particular, it should not
be used for babies or infants, persons who are insensitive to heat, helpless persons, or animals. Any use not
described above, or modifications of the underblanket are not permissible and may lead to injury and /or
damage to the product. The manufacturer assumes no liability for damage due to improper use.
Safety System
The heated underblanket is equipped with a safety system. The electronic sensor technology prevents the
entire surface of the underblanket from overheating by automatically switching off in the event of a fault. If
the safety system switches the underblanket off automatically due to a fault, then the heating indicator light
on the controller is no longer illuminated, even if the underblanket is switched on.
NOTICE
• Please note that, for safety reasons, the underblanket must not be used after a fault and must be returned
to the service address indicated.
• Never connect the defective underblanket to another controller of the same type. This would also result in
a permanent shutdown by the safety system in the controller.
5� To Use
1. The control connector must be connected to the underblanket connector before plugging the unit into
an electrical outlet. After connecting the underblanket connector to the control connector, plug the unit
into a 120 VAC electrical outlet.
Control Connector
Underblanket Connector
1
2
7
7
8
5
6
4
3

Publicidad

Tabla de contenido
loading

Tabla de contenido